During the circuit inspection of Forever E-Bike china, turn on the power switch to check whether the circuit is unblocked, whether the connectors are firmly and reliably inserted, whether the fuse works normally, especially whether the connection between the battery output terminal and the cable is firm and reliable. If a fault is found, it should be eliminated in time.
Before traveling, you should check the power of the battery, and judge whether the power of the battery is sufficient according to the mileage of the trip. If the power is not enough, it should be properly supplemented by manpower riding to avoid battery undervoltage work.
You should also check the working condition of the motor before traveling. Start the motor and adjust its speed to observe and listen to the operation of the motor. If there is any abnormal phenomenon, it should be repaired in time.

Before using electric bicycles, check the lights, horns, etc., especially when traveling at night. The headlights should be bright, and the light beam should generally fall within the range of 5-10 meters in front of the front of the car; the sound of the horn should be loud and not hoarse; the turn signals should flash normally, and the direction indicators should flash normally, and the flashing frequency of the lights should be 75-80 times per minute; The display should be normal.
Before traveling, check whether the main fasteners of Forever E-Bike china are fastened, such as handle bars, stem tubes, saddles, saddle tubes, front wheels, rear wheels, center axles, lock nuts, pedals, etc. The fasteners should not be loose. If the fasteners are loose or fall off, they should be tightened or replaced in time. The recommended torque distance of each fastener is generally: 18N.m for the handle bar, stem tube, saddle, saddle tube, front wheel, and pedals, and 30N.m for the center shaft lock nut and rear wheel.